Oxy-Fuel Burning & Plasma Cutting
Oxy-Fuel Burning and Plasma Cutting
Concord Steel has state-of-the-art tables that can handle plate up to 270″ wide and 16″ thick. And all our tables are new or recently rebuilt. You won’t find another source for Oxy-Fuel or Plasma burning in the region that can match our capacity or quality.
Laser Cutting
Laser cutting works by directing a high-power pulsed laser at a specific location on the material to be cut. The energy in the laser beam is absorbed into the surface of the material and the energy of the laser is converted into heat, which melts or vaporizes the material. Additionally, gas is focused or blown into the cutting region to expel or blow away the molten metal and vapor from the cutting path.
There are numerous advantages of laser cutting over mechanical cutting such as plasma cutting or turret punching. All of the following advantages result in dramatic cost savings.
Laser Cutting Advantages
- High accuracy cuts with excellent repeatability
- Produces clean cutting edges which require minimal finishing
- Smaller cut taper than other methods
- Minimal heat input, low edge loads during cutting — less distortion
- No physical contact with the material — no metal contaminates can embed into the material
- Complex shapes, very intricate and difficult geometric cuts possible
- No expensive tooling to add to the cost
- No tooling makes prototyping parts inexpensive and fast
- Increased cutting speeds and higher throughput
- Cut several parts simultaneously
- Allows nesting of like materials and thicknesses together on the same plate
Concord Steel has state-of-the-art tables that can handle plate up to ¾ thick.
Oxy-Fuel Torch Tables
Manufacturer | Specifications |
---|---|
Si-Tech 2 units |
12 Torch Oxy-Fuel Burny 10 CNC controls Cut Size: 252″ wide x 280′ long New April 2002 |
Esab | 12 Torch Oxy-Fuel Burny 10 CNC controls Cut Size: 220″ wide x 83′ long Total rebuild June 2002 |
Esab GxL-2000 | 8 Torch Oxy-Fuel Esab CNC controls 24″ thickness capacity Cut Size: 270″ wide x 55′ long Total rebuild in 2003 |
Esab | 12 Torch Oxy-Fuel Burny 10 CNC controls Cut Size: 220″ wide x 63′ long Total rebuild November 2002 |
Sector 2 units |
24 Torch Oxy-Fuel Burny 10 CNC controlsCut Size: 220″ wide x 63′ long New in 2006 |
Plasma Table
Manufacturer | Specifications |
---|---|
Linde CM100 | 1000 amp single torch (2 x 500 amp Thermo Dynamics TA500 power sources) Burny 5 CNC Controls 14′ wide x 25′ long Water Table |
Laser Tables
Manufacturer | Specifications |
---|---|
Cincinnati CL-707 | 3300 Watt Laser 96 x 240 interchangeable tables cutting up to ¾ thick |
Cincinnati CL-707 | 3300 Watt Laser 60 x 120 interchangeable tables cutting up to ¾ thick |